- Posts: 50
- Thank you received: 3
Electrical
Zn1300 horn/mode switch
- Rage10
-
Topic Author
- Offline
- Senior Member
-
6 years 6 months ago #25462
by Rage10
Zn1300 horn/mode switch was created by Rage10
Hey all,
My horn/more switch is worn out. It keeps spitting detent balls to the wild grey yonder.
Has anyone made a reproduction one? I'm going to 3D print one sometime in the next week or two. I'm also gonna make it momentary both ways. The stock switch is built to hold on the mode function.
Any thoughts on this and does anyone want one? Pricing is TBT but I'm not gonna charge more then cost+shipping.
-isaac
My horn/more switch is worn out. It keeps spitting detent balls to the wild grey yonder.
Has anyone made a reproduction one? I'm going to 3D print one sometime in the next week or two. I'm also gonna make it momentary both ways. The stock switch is built to hold on the mode function.
Any thoughts on this and does anyone want one? Pricing is TBT but I'm not gonna charge more then cost+shipping.
-isaac
Please Log in or Create an account to join the conversation.
Moderators: scotch
Time to create page: 0.097 seconds